Rigol DS1074B Betriebsanweisung PDF herunterladen (Seite 129)

RIGOL

User’s Guide for DS1000E, DS1000D Series

2-99

Manual Mode

Figure 2- 121 Table 2- 79 The Manual Mode menu

Settings

Comments

Mode

Manual

Adjust the cursor to measure X/Y

parameters manually

Type

Shown as vertical line to measure the

horizontal parameters

Shown as horizontal line to measure

the vertical parameters

Source

CH1

CH2

MATH/

FFT

Select the measurement signal source.

(LA is only for DS1000D series)

In this mode, the oscilloscope measures the Y or X coordinate values of the cursors,

and the increments between the two cursors.

To do manual Cursor Measurements, please do as the following steps:

1. Select the Manual mode for cursor measurement by pressing soft button as:

Cursor→Mode→Manual.

2. Select channel Source for measurements by pressing soft button as:

Cursor→Source→CH1, CH2, MATH (FFT) or LA (DS1000D series)

NOTE: While measuring the channel of MATH, the results are valued with “d”

(division) as units.

3. Select the cursors type by pressing soft button as Cursor→Type→X or Y.

4. Move the cursors to adjust the increment between the cursors: (Details in the

following Table)

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 171 172

Keine Kommentare

Rigol DS1074B Betriebsanweisung Seite 129