Rigol DS1000M Betriebsanweisung PDF herunterladen (Seite 129)

RIGOL

User’s Guide for DS1000 Series

Menus and operations of Cursor Measurements

1. Manual Mode

Figure 2-120 Table 2-79

Menu Settings Comments

Mode Manual

Adjust the cursor to measure X/Y

parameters manually

Type

Shown as vertical line to measure the

horizontal parameters

Shown as horizontal line to measure

the vertical parameters

Source

CH1

CH2

MATH

FFT

Select the measurement signal source.

(LA is only applicable in Mixed Signal

Oscilloscope)

In this mode, the oscilloscope measures the cursors’ coordinate values for Y or X,

and the increment between the two cursors.

To do manual Cursor Measurements, please do as the following steps:

1. Select the Manual mode for cursor measurement by pressing soft button as:

Cursor→Mode→Manual.

2. Select channel Source for measurements by pressing soft button as:

Cursor→Source→CH1, CH2, MATH (FFT), or LA (Mixed Signal Oscilloscope)

NOTE: While measuring the channel of MATH, the results are valued with “d”

(division) as units.

3. Select the cursors type by pressing soft button as Cursor→Type→X or Y.

4. Move the cursors to adjust the increment between the cursors: (Details in the

following Table)

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 167 168

Keine Kommentare

Rigol DS1000M Betriebsanweisung Seite 129