Rigol DS1000M Betriebsanweisung PDF herunterladen (Seite 137)

RIGOL

User’s Guide for DS1000 Series

Chapter 3 : Application & Examples

Example 1: Taking Simple Measurements

The function is used to observe the unknown signal and display and measure the

frequency and peak-to-peak amplitude.

To quickly display a signal, please do the steps as follow:

1. Set the probe and the channel attenuations to 10X

2. Connect signal to CH1 with the probe

3. Press the AUTO button

The oscilloscopes set the vertical, horizontal, and trigger controls at the best status

automatically. To optimize the display of the waveform, you could adjust these

controls manually to meet your requirements.

Selecting Automatic Measurements

The oscilloscope could take automatic measurements on most signals. To measure

the frequency and peak-to-peak amplitude, do these steps as follows:

1. Measure peak-to-peak amplitude

Press Measure→Source→CH1 to set measurement source

Press Voltage →Vpp to select peak-to-peak measurements and the result will be

displayed on the screen.

2．Measure frequency.

Press Measure→Source→CH1 to set measurement source

Press Time→Freq to select peak-to-peak measurements and the result will be

displayed on the screen.

NOTE: The frequency, period, and peak-to-peak measurements are shown on the

screen and are updated periodically.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 167 168

Keine Kommentare

Rigol DS1000M Betriebsanweisung Seite 137