
Chapter 3 Commands Compatibility RIGOL
Programming Guide for DM3000
Fluke Commands Compatibility
The following table lists the commands of Fluke that supported by RIGOL DM3000
series digital multimeters.
Before using these commands, please select the Fluke commands by CMDSet
command - CMDSet FLUKE. For more details on this command, please refer to the
“Commands Introduction” in Chapter 1.
NOTE: The contents in item “Function” from the table below refer to application of
Fluke Commands in RIGOL DM3000 series digital multimeters.
Fluke
Turns on the AC current measurement function.
Turns on the DC current measurement function.
Turns on the AC voltage measurement function.
Turns on the AC voltage measurement function.
Turns on the continuity measurement function.
Turns on the diode measurement function.
Turns on the frequency measurement function.
Turns on the frequency measurement function under the secondary
display while it is in AC measurement.
Turns on the resistance measurement function.
Switches to the 2-wire resistance measurement function.
Switches to the 4-wire resistance measurement function.
Queries the current main measurement function.
Query the current measurement function under the secondary
display. Note this command is available only for AC measurements.
Clears the secondary function. Note that this command is available
only when the frequency measurement function is turned on for AC
measurements.
Turns on the DB measurement function.
Exits the DB measurement function.
Sets the DB reference value.
Queries the DB reference value.
Turns on the Touch Hold function of the meter.
Kommentare zu diesen Handbüchern